On today's lesson I also started to do my actual lamp. I've started putting all the dots on my piece of aluminium, where I have to start curving, where is the center of curve and where is the end of curve. Because most of the lesson I was doing all the drawings, so I haven't done much of the work with the lamp. But I'll try all my best on the next lesson to do as much as possible.
I got a bit confused about the measuring the aluminium piece. How should I measure where is the beginning of the curve, where is it's center and where does it have to end. I'll figure it out on the next lesson.
I got a bit confused about the measuring the aluminium piece. How should I measure where is the beginning of the curve, where is it's center and where does it have to end. I'll figure it out on the next lesson.
No comments:
Post a Comment